• Properties

    Property
    Max. flow 176 GPM
    Max. (discharge) pressure 217.5 PSI
    Viscosity 1000000 cPs
    Max. temperature 284 °F
    Certificates 1934-2004 EC. FDA. USP. EAC 
    Port 38-80 mm
    Speed Max 960 rpm 
    Materials Wetted Parts 316 stainless steel (1.4401)
  • Description

    The LT series are hygienic truck loading/unloading pumps. All product-wetted parts are made from 1.4404/316L stainless steel, to match highest hygienic standards. The use of compact, direct-coupled hydraulic motors enables space-saving and flexible installation.

Pump series LT

The LT series are hygienic truck loading/unloading pumps. All product-wetted parts are made from 1.4404/316L stainless steel, to match highest hygienic standards. The use of compact, direct-coupled hydraulic motors enables space-saving and flexible installation.

  1. Epoxy coated lightweight aluminum gearbox and gearbox cover.
     
  2. Smaller clearances result in less slip which results in better efficiency when pumping low viscous fluids.
     
  3. Design and position of the seals, brings the CIP-fluid in direct contact with them.
     
  4. Wetted seal parts can be replaced without disassembling the rotor case: pump does not need to be mounted out of the installation to change seals.
     
  5. Food grade oil-filled gearbox increases bearing lifetime and requires minimal service effort.
     
  6. Hollow shaft design allows space saving direct coupled hydraulic motor installation.

Application areas

LT truck pumps are designed to handle low and high viscous products in bi-directional operation, they offer a very good efficiency especially with low viscosity products . A high displacement, good suction capability and good cleanability are further features of the LT series. With the direct coupled hydraulic motor the LT is best suited to be installed in small areas, or where no electric drive is possible.

Your benefits

  • Cleaner

  • Certified to EC1935/2004, and 3A versions available
    - Wetted surfaces with Ra < 0.8 μm
    - Wetted parts in SS316L/ 1.4404
  • Improved CIP performance

  • - Optimized design to eliminate dead-spaces, O-ring grooves without dead corners.
    - Wetted parts of mech. seal directly in the product stream.
  • Faster maintenance
    - Pump can stay in piping/truck during replacing seals thanks to front loaded seals.
    - No need to open gearbox for adjusting axial clearances between rotors and casing.
    - Rotor change without timing
  • Extended service intervals
    • The oil-lubricated gearbox avoids frequent relubrication of the bearings with grease.
    • This reduces maintenance and increases operational reliability.
  • Universal mounting
    - Pumps can be mounted with both horizontal and vertical port connections.
    - Direct coupled hydraulic motors allow an operation where no electrical drives are possible.
    - Short mounting dimensions also for narrow space conditions.
  • Heating jackets for casing and front cover, pressure relieve valve and many more options available.
  • Shorter downtimes/higher flexibility